Benissimo , le RAM sono arrivate! ora provo i settaggidjlegend ha scritto:EdoEvolution ha scritto:Purtroppo virus e febbre un casino...Scusate raga se non sono piu rientrato ma è stato un trauma!! Ora sono all'università ed ho venduto le mie corsair dominator 3x2gb 2000mhz; quando tornerò a casa riacquisterò le dominator gt CMT12GX3M3A2000C9 e allora si che saranno dolori!! ehehenon appena le porto in casa e le metto su cambio il bios e provo i settaggi...ma ovviamente dovranno essere diversi inquanto le 12gb sono cas9...quindi nel frattempo aspetto le modifiche ai settaggi da parte di djlegend
Con le nuove ram setta cosi:
BIOS TEMPLATES:
Fammi sapere.Codice: Seleziona tutto
LN2 Mode: [Disabled] QPI Loadline Calibration: [Enabled] Sync Mode: [Enabled] AI Overclock Tuner: [Manual] OC From CPU level Up: [Auto] 2D Performance Booster: [Disabled] CPU Ratio Setting: [20.0] CPU Turbo Power Limit: [Disabled] >CPU Configuration---------------------------- CPU Ratio Setting [20.0] C1E Support: [Disabled] Hardware Prefetcher: [Enabled] Adjacent Cache Line Prefetcher: [Enabled] MPS and ACPI MADT ordering: [Modern] Intel(R) Virtualization Tech: [Enabled] CPU TM Function: [Disabled] Execute Disable Bit: [Enabled] Intel(R) HT Technology: [Enabled] Active Processor Cores: [All] A20M: [Disabled] Intel(R) SpeedStep(TM) Tech: [Disabled] Performance/Watt select: [Power] Intel(R) C-STATE Tech: [Disabled] C State package limit setting: [Disabled] ---------------------------------------------- BCLK Frequency [200] PCIE Frequency [101] DRAM Frequency [2000] UCLK Frequency [3208] QPI Link Data Rate [7118] Memory Configuration Protect [Disabled] ---------------------------------------------- >DRAM Timing Control-------------------------- CAS# Latency [9] RAS# to CAS# Delay [9] RAS# PRE Time [9] RAS# ACT Time [24] RAS# to RAS# Delay [Auto] REF Cycle Time [90] WRITE Recovery Time [Auto] READ to PRE Time [Auto] FOUR ACT WIN Time [Auto] Back-To-BackCAS# Delay [Auto] Timing Mode [1N] Round Trip Latency on CHA [52] Round Trip Latency on CHB [54] Round Trip Latency on CHC [56] WRITE To READ Delay(DD) [Auto] WRITE To READ Delay(DR) [Auto] WRITE To READ Delay(SR) [Auto] READ To WRITE Delay(DD) [Auto] READ To WRITE Delay(DR) [Auto] READ To WRITE Delay(SR) [Auto] READ To READ Delay(DD) [Auto] READ To READ Delay(DR) [Auto] READ To READ Delay(SR) [Auto] WRITE To WRITE Delay(DD) [Auto] WRITE To WRITE Delay(DR) [Auto] WRITE To WRITE Delay(SR) [Auto] ----------------------------------------------------------- CPU Differential Amplitude: [Auto] CPU Clock Skew: [Auto] IOH Clock Skew: [Auto] ------------ Extreme Engine Digi+ ----------------------- Digi+ PWR Mode: [T-Balanced] PWR Volt. Control: [Auto] Load-Line Calibration: [Full] CPU Voltege OCP: [Ensabled] CPU PWM Frequency: [Auto] Extreme OV: [Disabled] Extreme OC: [Auto] CPU PLL Voltage: [1.32] QPI/DRAM Core Voltage: [1.35] DRAM Bus Voltage: [1.654] >DRAM REF Voltages------------------------------------ DRAM DATA REF Voltage on CHA: [Auto] DRAM CTRL REF Voltage on CHA: [Auto] DRAM DATA REF Voltage on CHB: [Auto] DRAM CTRL REF Voltage on CHB: [Auto] DRAM DATA REF Voltage on CHC: [Auto] DRAM CTRL REF Voltage on CHC: [Auto] ---------------------------------------------------------- IOH Voltage: [1.15275] IOH PCIE Voltage: [Auto] ICH Voltage: [Auto] ICH PCIE Voltage: [Auto] *QPI Voltage OCP: [Disabled] *IOH Voltage OCP: [Enabled] *DRAM Voltage OCP: [Disabled] *QPI PWM Frequency: [Auto] *IOH PWM Frequency: [Auto] *DRAM PWM Frequency: [Auto] ---------- Spread Spectrum Control ----------- CPU Spread Spectrum: [Disabled] DRAM Spread Spectrum: [Disabled]
eheheh
